Cutting Corrugated Metal Panels?

Share Article

The roofing and siding industry will never be the same!....CTTI has a revolutionary new tool that solves the huge problem of cutting factory looking cuts and angles on corrugated metal panels.

Core Tech Tools Inc.(CTTI) Would like to introduce the "KleenKutter" (pat. pend.) our new tool.

Two years in the making for the construction industry, with the roofing and siding industry specifically in mind, CTTI has developed the ultimate circular saw workstation, The KleenKutter!

The KleenKutter's unique feature solves the problems of dangerous, jagged and rough looking cuts.

KleenKutter allows cuts up to 50 degrees without any blade change outs.

Chatter or vibrations that cause these negative cuts are things of the past with "The KleenKutter".

This tool's specially designed base plate accepts Skil or Bosch worm drive circular saws with 7 1/4" or 8 1/4" for deeper cuts. However, we can make a base plate to accommodate any circular saw upon request.

It's about time!......It's all about time!

The roofing and siding industry will have a new outlook on job time. With this revolutionary workstation, any construction that requires a lot of cutting will save time and money.

It is easily moved between job sites!

This tool will cut down costs of labor and materials allowing the industry to pass savings and quality on to their customers.

"It's the best way to cut sheet metal on the market!"

Leaves a factory cut everytime!

Standing seam

Sheet metal

Shingles

Siding

Metal tile

Sheets of plastic

Vinyl

Fiberglass

Stainless steel

are just some of the materials the KleenKutter can cut with ease.

CTTI realized there was a great need for the KleenKutter.

Tools to cut sheet metal were limited. Your choices left you with expensive, poor quality tools that required expensive blades for each angle and time consuming blade changes.

# # #

Share article on social media or email:

View article via:

Pdf Print

Contact Author

Scott Pardue