DreamLine Tetra is a frameless, square shower enclosure which is designed to be installed in a corner against finished walls
Aiken, SC (PRWEB) December 13, 2012
DreamLine Tetra is a frameless, square shower enclosure which is designed to be installed in a corner against finished walls. It uses anodized aluminum wall profiles for securing the stationary panel and the pivoting door; the profiles allow for up 1” width or out-of-plumb adjustments. The Tetra enclosure is reversible, thus it can be used in a left or right corner configuration. It can be installed on a custom-made tile floor pan or on a corresponding DreamLine white acrylic shower base.
The Tetra enclosure is made out of 3/8” thick, clear tempered glass. All visible hardware comes in polished chrome finish only.
Tetra SHEN-4134340-01 is 34” by 34” wide and 72 7/8” tall. One side of the enclosure consists of a stationary panel, the other side a pivoting door. The door is 30 1/2” wide; it leaves a 27 1/2” walk-in opening when fully opened. The front of the stationary panel (where it meets with the pivoting door) is secured with a metal rod installed at the very top of the panel and attached to the opposite wall. The pivoting door is sealed against the side panel with a magnetic strip running the full length of the door’s edge.
The Tetra enclosure can use a DreamLine SlimLine:DLT-1036360-00 white acrylic base with the drain located in a corner. The base is 36” x 36” wide by 4 3/4” tall. It needs to be noted that the shower base is slightly over three inches wider than the enclosure. The reason is that the base is attached directly to studs on two sides (in other words behind the finished wall), and the glass panels with the door are installed in the middle of the threshold.
DreamLine Tetra shower enclosures are now available at Warehouse USA – http://warehouse-usa.com. They are on sale with free shipping throughout 48 contiguous states. For more technical information or if in doubt, please do not hesitate to call 888-693-8066.