Mr Rooter Plumbing Endorses Southpointe B2B Trade Show: Visit Our Booth For FREE Plumbing Tips

Mr Rooter's Tip Of The Day: Stop by our booth for FREE plumbing tips. Meet Mr Winky and get plumbing advice from Mr Rooter.

  • Share on TwitterShare on FacebookShare on Google+Share on LinkedInEmail a friend
Southpointe Chamber Website
B2B Trade Show @ Southpointe Hilton Garden Inn

September 6th, 2012
Sponsored by Mr. Rooter Plumbing
Free admission to the general public
Doors open 12 noon to 5 PM

Pittsburgh, Pennsylvania (PRWEB) September 05, 2012

“Insulating water lines does not stop them from freezing,” warns Bob Beall, the plumber that offers the FREE second opinion on any plumbing job in the Northeast Ohio and Southwest Pennsylvania regions. “It basically delays the inevitable,” according to Mr. Rooter. The logic of insulating water lines is based on the hope that you can out wait the cold long enough for warmer temperatures to prevail–for example, says Beall, “when temperatures fall below freezing at night but rise above freezing during the day when the sun comes out.”

There are two materials that can be used to insulate water lines. Wrap them with fiberglass insulation(which rarely works very well) or snap on split-foam insulation. Those serious about insulating water lines, the snap-on foam, the thicker the better, should be used. According to the most referred plumber, “some varieties come with a peel-off backing that exposes a self-adhesive strip on the edges, sticking the edges together.” Absent the self-adhesive, duct tape must be used on the edges at intervals along its entire length.

Mr. Rooter’s Tip Of The Day

Tip #1 To start, cut the foam insulation to length and slip it onto the pipe.

Tip #2 Close the seam by peeling off the protective adhesive strip and pressing the edges together or by taping the seam.

Tip #3 To hand an insulated water line, use pipe hanger strapping or plastic J-hooks.

Tip #4 To insulate an elbow, either cut a slit out of the pipe and slide it onto the corner or cut a diamond pattern out of the foam and slide the cutout over the elbow.

BONUS TIP: Turning A Corner
To insulate an elbow, either cut out a triangular section of the insulation and slide the cutout to fit around the elbow, or, cut a rectangle out of a section and slide it on the elbow. Use whatever method makes it easiest to push the insulation around the elbow.

B2B Trade Show @ Southpointe Hilton Garden Inn

September 6th, 2012
Sponsored by Mr. Rooter Plumbing
Free admission to the general public
Doors open 12 noon to 5 PM

Mr. Rooter’s Daily Tips are provided by Mr. Rooter Plumbing. Subscribe today! (top right corner)
There’s A Reason They Call Us Mr.™

Debra Santavicca PR, SMM, WebIT
Mr. Rooter Media Center
724-553-9510

http://www.rooter2.com