"WirelessGuys were very professional and knowledgeable. They had all the skills needed to get everything we needed done."
Moorpark, CA (PRWEB) October 28, 2013
WirelessGuys announced this week, the successful use of the RADWIN 5000 series HPMP high-capacity Point-to-Multipoint (PTMP) base station to revitalize Rose Hills Memorial Park and Mortuary's outdated wireless infrastructure.
The wireless infrastructure previously employed by Rose Hills Memorial Park and Mortuary was a meshing hardware system with recently increasing RF issues. The primary challenge facing Rose Hills Memorial Park was replacement of its outdated wireless infrastructure. A secondary issue was the lack of good customer service from the current manufacturer's support team. The Rose Hills IT team initially contacted its IT vendor for a recommendation for replacement hardware. This led to a referral to RADWIN as a good solution. In turn, RADWIN referred the Rose Hills IT team to WirelessGuys, a Wireless Internet Solutions Provider with a reputation for furnishing wireless environments that work.
WirelessGuys was faced with numerous challenges at Rose Hills Memorial Park. Major wireless infrastructure concerns including basic hardware issues with the radio controller board made frequent radio board replacement and repairs a necessity. Also, the odd topographical layout of Rose Hills Memorial Park eliminated the possibility of a full mesh infrastructure. Eight buildings on the Rose Hills Memorial Park campus were previously connected via three base stations with multiple antennas at the main tower. The system was outdated and in need of replacement for connectivity between the buildings. Newer technology with advanced features including some MIMO and higher bandwidth was also desired by Rose Hills personnel.
All of Rose Hills Memorial Park's needs were quickly analyzed and remedied by WirelessGuys, a Wireless Services Integrator that specialized in the design, installation, and support of wireless networks. WirelessGuys' Professional Services Team quickly ascertained the need for a Point-to-Multipoint (PTMP) wireless network. The outdated mesh system was removed and a new system comprised primarily of RADWIN components was designed and installed. Considering the expansive coverage area and unusual topographics at Rose Hills Memorial Park, WirelessGuys opted to install the RADWIN 5000 series high-capacity Point-to-Multipoint (PTMP) base station on the main tower. The RADWIN 5000 HPMP base station supports up to 250 Mbps per sector and delivers high capacity over a single radio unit. It also provides high spectrum efficiency in the Point-to-Multipoint arena for greater throughput over narrower channel bandwidth.
An added 90 degree sector antenna on the tower was positioned so the CPEs on the eight campus buildings connected to the single access point to provide improved throughput. Additionally, more bandwidth was needed to the Administration building where the majority of Rose Hills Memorial Park business is conducted. Previously, there was only one CPE going to the Administration building. The WirelessGuys design included bypassing that CPE and adding a dedicated RADWIN Point-to-Point (PtP) link with a dedicated 100 MHz full duplex backhaul going to the tower. WirelessGuys also integrated its own 1U Smart UPS to provide power to all equipment on the tank for two hours in the event of a power failure. The WirelessGuys Professional Services Team basically designed and installed two systems with built-in redundancy for Rose Hills Memorial Park and Mortuary.
As a solution to the need for improved customer service, the wireless network infrastructure employed by WirelessGuys was installed with the capacity for remote monitoring, rebooting, firmware updating and channel switching. Remote monitoring by WirelessGuys allows for immediate troubleshooting and reduces remediation time from an entire day to even a few minutes.
Rose Hills Memorial Park personnel described a positive experience with WirelessGuys and noted that "Everything's been fine." The WirelessGuys Professional Services Team was described as "Very professional and knowledgeable. They had all the skills needed to get everything we needed done."
WirelessGuys is the premier reseller of complete end-to-end wireless technologies and solutions. With more than 50 years combined Professional Services Team member experience, WirelessGuys is a highly qualified integrator specializing in point-to-point (PtP) wireless backhaul, point-to-multipoint (PTMP) wireless bridges, WiMax backhaul, municipal WiFi, SOHO, DAS, and beamforming products for both indoor and outdoor applications. Employing both licensed and unlicensed wireless connectivity, WirelessGuys delivers the highest level of knowledge and expertise to a wide range of customers including WISPs, telcos, municipalities, utility companies, and schools. WirelessGuys provides solutions to both new and established businesses worldwide.
WirelessGuys' suite of services includes site surveys, site acquisition, feasibility studies, RF and spectrum analysis, microwave path calculations, RF engineering and design, system troubleshooting, and remote access and monitoring of wireless backhaul networks.
WirelessGuys is a Parts, Smarts and Labor company offering design, sales and installation services as well as preventative network health maintenance and remote monitoring. WirelessGuys' networking and communications products combines both brand name manufacturers and innovative customer specific proprietary systems designed to increase the range and reliability of wireless networks.
All WirelessGuys engineers and technicians are cross trained in all sectors and provide a unique synergy that delivers cutting edge solutions to the most critical issues facing current wireless networks. WirelessGuys benefits its customers by leveraging its deep integration expertise and extensive wireless knowledge to reduce deployment costs, increase ROI, and ensure consistent performance in even the most challenging environments.
Offering a global reach with a local flare, WirelessGuys is well positioned as a forerunner in the wireless solutions arena. Regardless of the application, WirelessGuys' end-to-end product portfolio enables them to custom build a wireless solution to fit any customer's needs. For more information, call 1-800-945-3294, email admin(at)wirelessguys(dot)com or visit http://www.wirelessguys.com.