InventHelp® Introduces New Necktie Accessory That Keeps All Parts of Tie in Place

Share Article

InventHelp is seeking marketers and distributors in the menswear and apparel/accessories industries, and direct response industries.

InventHelp introduces the “Total Tie Keep” a patented device designed to keep all parts of a necktie in place, while remaining out of sight. The accessory which stabilizes the necktie without creating a stiff, unnatural appearance, was recently featured on ABC’s show Shark Tank.

Total Tie Keep is a product that addresses a long standing tie wearer problem. Wind and movement can cause the rear tie to pop out, blow loosely in the wind or slide to one side. Total Tie Keep remedies all of these common problems so the wearer no longer suffers from tacky tie behavior and an embarrassing representation. Total Tie Keep buttons on to a shirt and anchors the tie label and the rear tie.

Total Tie Keep is made of 100% pre-shrunk cotton. It is approximately 7/8” wider than other similar cloth-made products, which not only accommodates the width of the rear tie, but it also provides additional stabilization for the entire tie by maintaining more significant contact to the tie label. These features help to eliminate excessive movement. Total Tie Keep does not stiffen up the tie, a problem with other products. Total Tie Keep allows the tie to move naturally with just the right amount of restraint while still remaining virtually invisible. Suggested retail price: Pack of 4: $ 24.95, plus shipping and handling.

InventHelp is seeking marketers and distributors in the menswear and apparel/accessories industries, and direct response industries. Total Tie Keep is available on http://www.inventhelpstore.com, a website of innovative new products by InventHelp’s licensing and product marketing partner Intromark Incorporated. For more information, or for ordering, contact us at 217 Ninth Street, Pittsburgh, PA 15222; call (800) 851-6030 or (412)288-1368; fax (412) 338-0497 or email Licensing(at)intromark.com.

Manufacturers interested in reviewing additional inventions and new product ideas can contact Intromark by filling out an online request to review new product ideas here.

# # #

Share article on social media or email:

View article via:

Pdf Print

Contact Author

Gia DelliGatti
InventHelp
+1 (412) 288-2136 Ext: 4163
Email >

INPEX
@inventhelp
Follow >
InventHelp®
Like >
Follow us on
Visit website