Hydro Engineering new Drive In Clean Out Tray simplifies solids / liquid separation in above ground vehicle and equipment wash racks.
For over forty years, Hydro Engineering Inc. has been in the business of vehicle and equipment wash rack designs. Now, available as equipment and not a construction project! It's all about safety, effectiveness, reducing labor and exceeding environmental requirements.
SALT LAKE CITY, July 15, 2020 /PRNewswire-PRWeb/ -- There are many factors that go into a wash rack design;
- Location and climate
- Utilities available (power, water, sewer)
- Vehicles and/or equipment to be serviced
- Demand (units per day, turnaround time, etc.)
- Application (for appearance or corrosion control maintenance)
Solids/liquid separation is a primary consideration of any wash rack design. If minimum 95% of solids are removed at wash pad, then wastewater filtration, treatment and recycling equipment will require less maintenance.
OBJECTIVE: Remove solids at wash pad.
SOLUTION: Hydro Engineering Inc. Drive In Clean Out Tray
Hydro Engineering Inc has been designing drive in clean out systems for concrete wash pads for decades. Now we can incorporate a drive in clean out tray to our Patented Hydropad all steel above ground wash pad systems. Keep solids at wash pad for clean out convenience.
Hydropad model 2ZV237 Drive-in Tray is basically a heavy-duty solids settling system. Wash wastewater flows by gravity from a Hydropad above ground steel containment wash pad side gutter into Drive-in Tray. Weirs located in tray quiesce flow to promote solids settling. Clarified liquid enters an integral sump tank for pump discharge to subsequent filtration. As required, a skid-steer is used to remove accumulated solids in tray using tray entry/exit ramps. This system is ideal for operations with heavy soil loads.
SOURCE Hydro Engineering, Inc
Share this article